My first attempts to set rivets!
About 50% were okay.
Some flush rivets became slightly too countersinked.
(i gueess)
The universal ones is okey from this side.
(no smileys)
On the back-side we can se that some rivets are over-squeezed.
(more practise)
My Hand Rivet Squeezer/Dimpler
and my first dimpled holes!
Two of them just a little over-dimpled.
(i guess)
The two types of rivets that i tested with.
470 is the Universal head Rivet.
426 is the Flush head Rivet.
Slim Micro-Stop.
Countersink Bit #30 (and #40 mounted).
Deburr/Countersink 100 degrees.
AES 3/8 Chuck Drill 4000 rpm (nice sound).
#40, #30 Drill bits.
Automatic center punch.
Cleco Pliers.
"K" Cleco 1/8 fasteners.
Rivet 3X Gun (nice sound).
Rivet snap 1/8 (mounted).
Back Rivet Set.
